Talk-to-Listen Ratio: What the Sales Data Says, How It Changes by Call Type, and How to Coach It
The talk-to-listen ratio is the share of a sales call the rep spends talking compared with listening. Gong's 2025 analysis of 326,000 sales calls found the average rep talks 60% of the time: 57% on deals they won and 62% on deals they lost. The widely quoted 43:57 comes from Gong's 2016 data and works as a direction, not a target. On demos, winning and losing calls both ran about 65:35, and what separated them was how the talking was broken up.
Share of the call the rep spent talking
326K
calls in the 2025 data
65:35
winning demos
66:34
losing demos
Blue: rep talking. Purple: buyer talking. Figures: Gong Labs, read November 2026.
What Is the Talk-to-Listen Ratio?
The talk-to-listen ratio is the percentage of a call's speaking time taken by the seller, written against the percentage taken by the buyer. A 60:40 ratio means the rep spoke for 60% of the time anyone was speaking and the buyer for 40%.
The formula is rep speaking time divided by rep plus buyer speaking time. Silence, hold music, and the pause while a screen loads are left out, which is why the two numbers always add up to 100. Conversation intelligence tools such as Gong, and phone systems such as Aircall and CloudTalk, calculate it from recordings that separate the speakers.
Managers like the number because it is easy to read and hard to argue with. It is also easy to over-read. The pages that rank for this term mostly repeat one figure, 43:57, without its date, and say little about how the right ratio changes between a cold call and a demo, or what the number misses.
One disclosure: SnapSDR is an AI demo agent that runs on Tough Tongue AI's agent infrastructure. It comes up once, in the section on AI agents. Nearly all the data below comes from Gong Labs, which sells conversation intelligence software. We read each Gong page in November 2026 and give its date.
What Is a Good Talk-to-Listen Ratio?
For most calls, somewhere between Gong's 2016 best split of 43% rep talk and the 57% it measured on won deals in 2025. Discovery calls belong near the low end; demos run higher. Only a few primary data sets sit behind any of these numbers, and all four below are Gong's.
| Source | What it found | Based on |
|---|---|---|
| Gong Labs, 2016 | 43% talking to 57% listening was the best-performing split. Talking more than 65% of a call went with lower conversion and win rates. | Original analysis by Chris Orlob. The current page does not give the 2016 sample size. |
| Gong Labs, 2025 update | The average call is 60:40. Reps on deals they won talked 57% of the time; on deals they lost, 62%. | 326,000 sales calls of 10 minutes or more. Updated March 2025, page last modified March 2026. |
| Gong Labs, demos | Winning demos ran 65:35 and losing demos 66:34. Gong calls the gap too small to act on. | 67,149 recorded demos. Published 2017, last modified March 2026. |
| Gong Labs, cold calls | Successful cold calls had a higher rep talk share than unsuccessful ones, and 77% more speaker switches per minute. | A database of over 100,000 recorded cold calls. Published 2018, last modified March 2026. The talk ratio is shown as a chart without numbers. |
43:57 is the shape of a good call, not a number to hit. Gong's own 2025 update found that won and lost deals are five points apart (57% against 62% rep talk) and called the gap modest. Reps on winning deals still talked more than they listened. A rep at 55% has not failed, and a rep at 43% who never asked about budget has not succeeded.
The famous figure has drifted from its source. Aircall's 2023 guide, citing Gong, put the typical rep at about 70:30; Gong's 2025 average is 60:40. Some pages credit 43:57 to a HubSpot article named after 25,537 calls. That HubSpot address now redirects to an unrelated post on prospecting, so the claim can no longer be checked there.
Over 65% is the one line worth holding. The 2016 analysis tied talking more than 65% of a call to lower win rates, and the 2025 losing-deal average sits at 62%. If a rep's discovery calls run above 65%, that is worth a coaching conversation. Demos are the exception, as the next two sections show.
Why Does the Pattern Matter More Than the Ratio?
Because two calls with the same ratio can feel completely different to the buyer. One is a lecture with pauses for questions. The other is a conversation. Toggle between them:
Two 30-minute calls with the same 60:40 talk-to-listen ratio. Each block is one turn; width is how long it lasted.
60:40
talk-to-listen
4:00
longest rep turn
5:00
longest buyer turn
0.3
speaker switches a minute
Lecture
Five long stretches of pitch with the buyer answering in between. The buyer gets one good five-minute story in, but every rep turn runs three to four minutes. This is the shape Gong found in losing demos, where uninterrupted pitches ran up to 106 seconds.
The two calls are invented to show the idea. The findings they illustrate are from Gong's analysis of 67,149 recorded demos.
Gong's data points the same way in four places.
- Monologue length. Losing demos had uninterrupted pitches of up to 106 seconds. Gong reports it found no demo that led to a closed deal with more than 76 seconds of pitch without a break.
- Back and forth. Winning demos had 21% more speaker switches per minute than losing ones. Successful cold calls had 77% more.
- Consistency. In the 2025 data, high performers kept about the same ratio whether they won or lost. Lower performers swung from 54% rep talk on deals they won to 64% on deals they lost, which suggests they talk more when a call goes badly.
- Questions. More questions did not help. Won deals averaged 15 to 16 questions per call and lost deals about 20. A rep firing questions can hit a good ratio and still run an interrogation.
So the useful numbers are three: the ratio, the rep's longest monologue, and the buyer's longest answer. If your tool shows only the first, open the recording and find the other two by hand on a few calls.
Does the Right Ratio Change by Call Type?
Yes, because each call has a different job. On discovery the buyer is the source of information, so they should talk most. On a demo the product is the subject, so the rep talks more, and Gong's data shows winners and losers both near 65:35. Only the demo range below rests on published numbers; the rest are a starting point, marked as such.
Pick the call, set the talk time from your recording, and see where it lands.
60:40. Working range for a discovery call: 35 to 50% rep talk. The buyer is not telling you enough to plan the demo. Swap one statement for an open question and wait two seconds after each answer.
Our starting rangeDiscovery is the call where the buyer should do most of the talking. It is the call Gong's 2016 ratio of 43:57 fits best.
Only the demo range rests on published data. The others are a starting point based on what each call is for. Silence and hold time are left out, as in the tools that measure this.
If you coach demos, the sales demo script guide builds the 76-second line into each section of the template. For discovery, the discovery call questions list gives a follow-up for every question, which is the simplest way to get a buyer to keep talking.
How Do You Calculate the Talk-to-Listen Ratio?
Add up the minutes each side spoke and divide the rep's minutes by the total. A 30-minute call where the rep spoke for 15 minutes, the buyer for 10, and 5 minutes went to silence and screen loading is 15 divided by 25: 60:40. Done by hand it takes a recording and a stopwatch; any tool that transcribes with speaker labels does it for you.
The arithmetic is easy. The mistakes come from what goes into it:
| Problem | What goes wrong | Fix |
|---|---|---|
| Two sellers on the call | An AE at 35% and an SE at 35% each look fine. The buyer got 30% of the call. | Report the seller side combined, then each rep. |
| Several buyers | One buyer did all the talking for their side. The others never spoke. | Count how many buyer voices spoke at all. |
| One audio channel | Speaker separation mistakes move time to the wrong side. | Spot-check the transcript of any call that looks odd before coaching on it. |
| Short calls | On a four-minute call one long answer swings the ratio by 20 points. | Leave out calls under 10 minutes, as Gong's 2025 analysis did. |
| One average for every call type | Cold calls and discovery calls cancel each other out, and the team average says nothing. | Report the ratio by call type, never as one team number. |
The multi-seller case matters most for demos, where an AE and a sales engineer often share the call. Each can look well behaved while the buyer gets less than a third of the time. Read the seller side as one team first.
How Do You Improve Your Talk-to-Listen Ratio?
By changing a habit, not by aiming at a number. Telling a rep to talk less makes them quieter and vaguer. Telling them to stop opening with a five-minute company overview fixes the ratio as a side effect. These six habits account for most high-ratio calls:
| If the rep | Why the ratio climbs | Try this |
|---|---|---|
| Opens with five minutes on the company | The longest monologue of the call happens before the buyer has said anything. | Agree the agenda in 30 seconds, then ask what made them take the call. |
| Asks two or three questions at once | The buyer answers the easiest one and the rep fills the rest. | One question, then wait. Gong calls this the two-second rule. |
| Answers a short question with a tour | A 20-second question gets a three-minute reply. | Answer in one sentence, show one screen, then ask whether that covers it. |
| Fills every silence | The buyer was about to add the useful part. | Count to two before speaking after an answer. |
| Narrates every click in a demo | The ratio stays near 65:35 but single stretches run past two minutes. | Stop at least once a minute with a question tied to a problem they named. |
| Summarizes for the buyer instead of checking | Long recaps turn into a second pitch. | Paraphrase in one sentence and ask whether you got it right. |
A weekly routine that works. Pull three recordings per rep, all of the same call type. Note three numbers for each: the ratio against the range for that call, the longest rep monologue, and the buyer's longest answer. Pick the single habit from the table that explains the worst of the three, and agree on one change for next week. Put those three numbers on your sales call scorecard so managers score the same thing.
Practice before the live call. Habits like stacking questions are hard to break on a real buyer. A short roleplay where the only goal is one question at a time, followed by two seconds of quiet, works better than a reminder in the call notes. Our sales role play scenarios include buyer briefs for discovery and demo calls.
Live alerts, used with care. Some tools warn a rep during the call when they have been talking too long. That can help a rep who knows the habit and is working on it. For everyone else it adds one more thing to watch while trying to listen. Our guide to real-time sales coaching covers when live prompts help and when they distract.
Does the Talk-to-Listen Ratio Apply to AI Agents on Calls?
Yes, and the failure mode is the same. An AI agent that runs a qualifying call or a demo can answer a short question with a two-minute product tour just as a new rep can. Because every agent call is transcribed, it is easier to check: ask the vendor for speaker-separated transcripts, look at the longest agent turn and the buyer's longest answer, and set a limit on turn length in the agent's instructions.
SnapSDR is one example. It is an AI demo agent that joins Google Meet or Zoom, shows the product through slides or a live browser, answers questions, and asks qualifying questions along the way. Its sessions are recorded and transcribed, so the same three numbers can be read off every demo it runs, and the instructions can be changed when a section runs long.
Frequently Asked Questions
What is a good talk-to-listen ratio in sales?
For most sales conversations, somewhere between 43% and 57% rep talk. Gong's 2016 analysis found 43:57 was the best-performing split, and its 2025 analysis of 326,000 calls found reps talked 57% of the time on deals they won and 62% on deals they lost. Discovery calls should sit near the low end. Demos run higher: Gong found winning demos at 65:35.
What is the 43:57 rule?
It is the finding from Gong's 2016 research that the best-performing sales calls had the rep talking 43% of the time and the buyer 57%. It is often quoted as a target. Gong's 2025 update found the average call is still 60:40 and that won deals averaged 57% rep talk, so treat 43:57 as a direction (let the buyer talk more), not a number every call must hit.
How do you calculate the talk-to-listen ratio?
Divide the rep's speaking time by the combined speaking time of the rep and the buyer, leaving out silence and hold time. A call where the rep spoke for 15 minutes and the buyer for 10 is 15 divided by 25, or 60:40. When two sellers are on the call, add their time together first, then look at each one.
What should the talk-to-listen ratio be on a demo?
Higher than on other calls. Gong's analysis of 67,149 recorded demos found winning demos at 65:35 and losing demos at 66:34, so the ratio barely separates them. Monologue length does: Gong reports it found no demo that led to a closed deal with more than 76 seconds of pitch without a break, while losing demos had pitches of up to 106 seconds.
Does a lower talk-to-listen ratio always mean a better call?
No. A rep can reach a low ratio by firing questions, and Gong's 2025 data found lost deals averaged about 20 questions per call against 15 to 16 on won deals. A rep can also stay quiet and never learn the budget or who decides. Check the rep's longest monologue and the buyer's longest answer alongside the ratio.
How do you track talk-to-listen ratio?
Use a tool that records calls and separates speakers. Conversation intelligence platforms such as Gong report it for every call, and phone systems such as Aircall and CloudTalk show it in their call logs. Without a tool, time one or two recordings by hand each week. Either way, report the ratio by call type rather than as one team average.
Measure the Ratio, Coach the Pattern
The talk-to-listen ratio is a good first look at a call and a poor target. The data behind it says reps who win listen a little more, stay consistent when a call goes badly, and never talk for long without letting the buyer in. On demos, the ratio hardly moves between winners and losers at all.
Our recommendation: report the ratio by call type, never as one team average. Flag discovery calls above 65% rep talk and demos with any stretch of pitch past 76 seconds. Each week, pick one habit per rep from the table above and check the same three numbers on next week's recordings.
A Demo Agent That Asks Before It Pitches
SnapSDR joins Google Meet or Zoom, runs the first demo through your slides or a live browser, asks your qualifying questions as it goes, and hands each deal to a rep with the full transcript.
Related Reading
SnapSDR Team
AI Sales Automation Experts